Adhesive dispenser with wall brackets; dispenser has a rectangular body and a curved, roll-back lid with a flat edge to assist in opening; a spring-loaded hinge holds a metal rod in place; on the rod is a cardboard tube with three rolls of adhesive; a small washer is present, likely a part of the h…
Adhesive dispenser with wall brackets; dispenser has a rectangular body and a curved, roll-back lid with a flat edge to assist in opening; a spring-loaded hinge holds a metal rod in place; on the rod is a cardboard tube with three rolls of adhesive; a small washer is present, likely a part of the hinge.
Number Of Parts
7
Part Names
a - dispenser - Size: Length 37.1 cm x Width 9.8 cm x Depth 9.2 cm
b - metal rod - Size: Length 36.0 cm x Diam. 1.3 cm
c - tube - Size: Length 31.4 cm x Diam. 2.4 cm
d - adhesive - Size: Length 7.7 cm x Diam. 3.7 cm
e - adhesive - Size: Length 5.1 cm x Diam. 6.4 cm
f - adhesive - Size: Length 5.1 cm x Diam. 4.2 cm
g - washer - Size: Depth 0.2 cm x Diam 2.0 cm
Provenance
Owned and used by Dr. Burns of Napanee, Ont., a 1947 graduate of the Queen's University Medical Program; some items belonged to Dr. Stratton, who held the Napanee practice prior to Dr. Burns.
Printed on the lid of the dispenser in red enamel paint: "MADE IN U.S.A. // ADHESIVE TAPE"; printed on flat edge of lid: "CLOSE COVER WHEN NOT IN USE // Johnson & Johnson"
Permanent Location
Storage Room 0010
0010-D4-1
Condition Remarks
Scratches and active corrosion below the surface of the enamel is visible; metal rod has scratches on surface; fabric of tape has yellowed quite a bit.
Copy Type
Original
Reference Types
Book
Reference Comments
"Hospital & Physicians Equipment and Supplies," by J.F. Hartz Co., 1960, p. 274 (similar to item #6H-950)